Xtool D1PRO 2.0 Series Drag Chain kit (The DRAG)
Not only does it look clean, but it’s the best way to keep your cables managed and completely away from your working area, avoiding costly accidents and extending your machine’s longevity.
Our kit includes everything you need – including all of the cables you need. Not to mention, they are pre-installed in the Drag Chain, so you can just plug and play. No modification needed.
Click here for Drag Chain Installation Manual
Watch Drag Chain Demo
Installation Video
The Drag kit includes
Standard D1PRO 2.0
- X Drag chain
- Carrier bracket
- Y Drag chain
- Y Gantry Bracket
- Pre-installed cables (extended cables for Module, X stepper and limit switch)
- Pre-installed air hose for Air assist
- Front cover for a clean look
- Side Y Clip
- All hardware needed for installation
Extended D1PRO 2.0
- X Drag chain
- Carrier bracket
- Y Drag chain
- Y Gantry Bracket
- Pre-installed cables (extended cables for Module, X stepper and limit switch)
- Pre-installed air hose for Air assist
- Front cover for a clean look
- Side Y Clips
- All hardware needed for installation
palethomas (verified owner) –
The xTool D1 Pro 2.0 is a great machine, but the cable management setup is one of the worst we have seen. Thanks to the Pixel Creations drag chain system, both the wiring harness and the air assist tube are neatly placed on the top of the frame. And, without any modification to the machine. The only alteration that we made was to have the air assist tube exit the 𝘤𝘦𝘯𝘵𝘦𝘳 of the drag chain instead of the end. This was because of the existing routing inside the enclosure.
𝐓𝐡𝐞 𝐀𝐥𝐢𝐯𝐞 𝐏𝐢𝐱𝐞𝐥 𝐗𝐭𝐨𝐨𝐥 𝐃𝟏 𝐏𝐫𝐨 𝟐.𝟎 𝐃𝐫𝐚𝐠 𝐂𝐡𝐚𝐢𝐧 𝐊𝐢𝐭 is the most straight forward, easily installed, non destructive solution for cable management that we have found.
Keep up the great work !
Upvote if this was helpful (0) Downvote if this was not helpful (0) Watch Unwatch Flag for removal